Toa DP-K1 - Manual (Page 65)

65
(2) Enter the IP address of the unit to be added, then
press the OK button.
The IP address is displayed on the Check IP
Settings screen when the data is obtained by
connecting to the added units on the DP-K1
Setting Software.
Step 3. Add the unit to be connected over a WAN to the list.
(1) Press the "Add" button.
Step 4. Delete the unit from the list.
Select the unit to be deleted, then press the
Remove button.
The selected unit is deleted from the Check IP
Settings screen.
Tip
Trough the steps from 1 to 4 above, settings related
to the networks have been completed, allowing the
PC to communicate with the units displayed in
"Connectable Devices."
Notes
• Network setting for the unit to be connected over a WAN cannot be changed using the method
described in Step 2.
If you need to change the network setting, connect such unit to a LAN and change the network
setting in advance.
• If you have entered incorrect figures for the IP address of the unit to be connected over a WAN,
delete such unit from the list once (Step 4 below), then add the unit by entering the correct IP
address again.