Toa DP-K1 - Manual (Page 53)

53
Step 5. Repeat Steps 2 – 4 to take measurements of all necessary points (up to 8 points).
Step 6. Set to ON the multi-point filter calculation selector button for the points to be used for multi-point filter
calculation.
Step 7. Press the Multi-point filter calculation button.
The multi-point filter is calculated based on the measurement data for the multi-point filter calculation
selector button set to ON.
The calculated result is displayed on the ARC view.
Step 8. Adjust the filtering values as required.
8.1. Adjusting the effectiveness of filter
The automatically created filter is set to the normal
value.
To make filtering more effective, press the
[Aggressive] button. To make filtering less effective,
press the [Subtle] button.
To revert the changed filtering back to the normal
value, press the [Normal] button.
8.2. Changing the filter characteristics manually
The automatically created filter can be changed
manually by dragging the filter point on the filter
curve or changing values with the Frequency
indication button or Gain indication button.
To revert the manually changed filtering to the original filtering, press the [Selected] or [All] button.
Pressing the [Selected] button returns only the filter point being selected to the Normal state that has
been automatically created, and Pressing the [All] button returns all the filter points to the Normal
state as well.
[Subtle] button
[Normal] button
[Aggressive] button
[All] button
[Selected] button