Upper threading – SINGER W211 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Raise needle bar to its highest position.
Lead thread through top plate thread guide (1)
and between tension discs (
Pull thread down around arm thread guide (3)
and up to take-up lever (4).
Lead thread through eyelet on take-up lever
from right to left and down through face plate
5), hooking thread into guide.
Pull thread down through needle clamp guide (
and through needle hole from front to rear (7).
Always use the same type of thread on top and
bottom as different sizes or types of thread will
cause tension problems.
Example: Polyester thread on the bobbin and
cotton thread on top will result in poor tension