The bobbin, Winding the bobbin – SINGER 4022 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

The Bobbin

Winding the Bobbin

Preparation Steps

1. Raise the pressor foot and turn

hand wheel toward you until
needle is in highest position.

2. {..oosen hand wheel ktiob A by

turning it toward you witti the
right hand while holding hand

wheel with the left hand.

3. Place thread spool on spool pin B

over the felt cushion. If spool

being used has a thread retaining

slit C, it should be placed at the
top.

Winding Steps

® Place spool of thread on spool

pin as instructed above.

® Lead thread around disc of rear

thread guide D, as illustrated, and

through small hole in l>obhin from
inside out.

® Snap bobbin onto spindle and

push bobbin to right to engage
bobbin Vv'inder.

0

Hold thread end, as shown, and

start the machine. Cut off thread
end after a few coils fiave been
wound.

0

When required amount of thread

has been wound (winding will

stop when bobbin is full), stop tfie
machine

and

cut

cotmecting

thread.

0

Push bobbin to loft and remove

bobbin from spindle.

0

Hold hand wheel and tighten

hand wheel knob.

13

Advertising
This manual is related to the following products: