Four-step buttonholing – SINGER 4022 User Manual

Page 46

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Four-Step Buttonholing

® Pattern Selector: As illustrated

® Stitch Width; 3»5 to suit fabric

® Stitch Length: F to 3

® General Purpose Needle Plate

® Buttonhole Foot

Preparation

® Attach buttonhole foot to the

machine. Refer to page 5 for addi­
tional information on changing

presser feet.

1. Raise presser foot lifter. Hold

upper thread lightly with left hand

and turn hand wheel slowly
toward you until needle enters the

plate.

BE CAREFUL THAT YOU DO
NOT RUN THE MACHINE DUR­
ING THIS PROCEDURE.

Continue turning hand wheel and
holding upper thread until needle
rises. Tighten your hold on upper

thread and bring up lower thread

in a loop. Release upper thread.
Slide scissors between foot A and
plate B and draw both upper and

lower threads diagonally toward

the back of the foot, leaving

approximately 10 cm (4 inches) of
thread.

® Set machine according to above

code.

2. Place fabric with buttonhole

marking lines under foot. Align
bar tack marking line C with
notches on the solid white section

of foot D.

A A

Advertising
This manual is related to the following products: