SINGER W8910 - Manual (Page 13)

Bobbin winding
Bobbin winding
Turn the empty bobbin until the small round dot on
one side is outward. Slide the bobbin onto the bobbin
spindle, which is located on the right side of the machine.
Raise the presser foot and thread the machine as
described on the previous page, but pull the thread from
the needle through the presser foot and the slot at the
front of the machine. Never run the thread direct from
the eye of the needle because it may result in a bent
needle.
Start from underneath and wind the thread around the
bobbin a few times. Pull the thread backward and insert
it up through the thread cutter until it is cut. Depress the
foot control. The machine will stop automatically when
the bobbin is full. Remove the bobbin and cut the thread
in the thread cutter.
Threading the lower thread
When the bobbin winding is finished, place the bobbin
beside its case with the marking upward. The thread
should run as shown in the figure. Place the bobbin in its
case without turning it around.
Slide the thread into the slot on the edge of the bobbin
case. Pull the thread in under the tension spring. Check
that the bobbin rotates in the direction of the arrow
(clockwise) when the thread is pulled.
The thread must be pulled in the direction of the
spring, otherwise the spring will be overloaded.
Insertion of the bobbin case
bJlAW WJkX.1 WUUl I m 'V.'XXXXXU UXX^ ^X WJ w V o UWXX V/X UXW i./vyw/u/xxx
case and to the right. Put the bobbin case into place.
Press the bobbin case until it clicks to ensure that it fits
properly.
The thread cutter is located to the left of the bobbin
case. Hold the thread end and draw the thread from
underneath and up toward the thread cutter. By doing so
the thread will be cut off and kept in place. Shut the
door.
^
11