SINGER 14U454B Ultralock User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
* Thread the looper area of the machine following
the yellow color coded thread guides 0'^®.
* Remove the cylinder cover (page 9) to expose the
lower looper for threading.
* Turn the hand wheel toward you until the lower
looper is at the far left.
* Pull 7.5
10 cm (3 ^ 4 inches) of thread through
thread guide
(J).
*
Insert the thread through the left end of the lower
looper. 0
* Drop the thread.
Note:
Use the tweezers that are in the accessory set
to aid in threading the looper.
* Turn the hand wheel toward you until the lower
looper is at the far right.
Pick up the thread and pass it through the hole in
the end of the looper ® .
* The thread should be positioned in the groove of
the lower looper.
* Pull about 5 cm (2 inches) of thread through the
looper and place it over the top of the upper
looper and to the back of the throat plate.
13