N f2 f g m – SINGER 15-91 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
22
There should be no necessity for removing or
taking this tension apart.
However if, for any
reason, it becomes necessary to remove the tension,
proceed as follows:
Turn the thumb nut (A, Fig. 19) away from jmu
(toward the left) until it stops at “0” on the num-
EUI39\
F
ig
. 19. N
eedle
T
hre
.^
d
T
ension
D
isassembled
bei'ed dial (C); then press in the dial to disengage
the pin (B) in the thumb nut and remove the thumb
nut, dial, stop washer (D), tension spring (F), indi
cator (G), the two tension discs (H), thread guard
plate (L), and the tension releasing pin (J), as shown
in Fig. 19. To remove the pin (J) from the stud (N),
take off the face plate and tilt it so that the pin
will drop out.
To Reassemble the Needle Thread Tension
Replace the face plate, insert the tension releasing
pin in the stud, place the thread guard plate on the
N F2 F G M
F
ig
. 20. R
eassembling
and
R
eplacing
the
T
ension