SINGER 15-91 - Manual (Page 63)

(C, Fig. 64) and the adjusting finger (F, Fig. 64).
To make a wider plait, move the adjusting finger
(F) back or toward the needle and turn the adjust­
ing screw (C) downward. To make a smaller
plait, turn the adjusting screw (C) upward. The
distance between plaits is regulated by the length
of stitch.
To Adjust the Ruffler for
Group Plaiting and Gathering
The ruffler can be adjusted for group plaiting by
lifting the adjusting lever (E, Fig. 65) and moving
61
F
ig
. 65
it to the right so that the top of the projection
(D, Fig. 65) enters the small slot indicated by the
star on the adjusting lever. This should be done at
the points where you wish to make the space be­
tween the plaits. The ruffler will then stop and
plain stitching will be made. When the desired space
has been made, adjust the lever (E) so that the pro­
jection (D) enters either the slot marked “6” or the
slot marked “ 12.” By alternately making groups of
plaits and plain spaces, as shown in Fig. 65, very
attractive woi’k can be produced.