Attaching the binder to the machine, Inserting the binding in the binder – SINGER 15-91 User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
42
Attaching the Binder to the Machine
Raise the needle to its highest position and remove
the presser foot from the machine by loosening the
APRON-
CENTER
4 .
ADJUSTINC
¥■■' i-/
SCREW
OUTSIDE
SLOT OF
SCROLL
BINDER
SCROLL
thumb screw which holds it in place. Compare the
foot of the Binder and the presser foot and you will
see that they are attached to the machine in the
same manner. Attach the Binder to the presser bar.
Turn the balance wheel slowly
toward you to make sure that the
Binder is properly attached to the
bar and that the needle goes through
the center of the needle hole.
Inserting the Binding in
the Binder
Cut the binding to a long point
to left, as shown. Insert the pointed
end in the binder scroll (Fig. 41)
u n t i l t h e p o i n t e d e n d c o m e s
through the lower end of the scroll.
F
ig
. 40
C
utting
P
oint
ON B
inding