SINGER 15-91 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
37
There are several ways of starting the hem at the
edge, but the most practical one is as follows;
F
ig
. 33. S
taeting
a
H
em
at
the
E
dge
1. Fold over about 5^" of the edge of the material
at the starting point for a distance of about one inch.
2. Place the material in the Hemmer at an angle
leading to the right at a point just beyond the fold.
3.
Draw the material toward you through the
Hemmer, as shown in Fig. 33, at the same time
making the second fold at the very edge. Continue
to draw the material through the Hemmer until the
edge is just under the needle. Place the upper and
lower threads together under the Hemmer foot and
assist in starting of the hem by slightly pulling the
threads from the back as the machine is run.