Removing the material, Crossing heavy seams – SINGER W511 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CHANGING
DIRECTION OF SEWING:

• Before changing direction,

stop the machine at the desired
point making sure that the
needle is down through the

fabric.

• Raise the presser foot, turn

the fabric to the desired posi­

tion, lower the presser foot
and continue sewing.

Note: When sewing with a twin
needle, it is necessary to raise

the needles above the fabric
before turning. Be cautious to

realign the fabric to the position

where the last stitch ends.

REMOVING
THE MATERIAL:

• After stopping the machine,

turn the hand wheel toward you

until the take up lever is at its
highest position.

• Raise the presser foot, then

draw the fabric gently to the

left rear of the machine, making

sure that the threads are under
the foot. This avoids bending
the needle.

• With two hands, lift the two

threads up and into the thread
cutter on the presser bar and
pull down firmly to cut the
threads.

17

CROSSING

HEAVY SEAMS:

When crowing heavy seams,
angle the fabric down into the
foot so that the foot can draw
the heavy area into the feeding
mechanism and pass over the
bulk easily.

Advertising