Procedure – SINGER W511 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Button Foot
Other Applications
Needle Position Selector and
Zigzag Width Control Dial
PROCEDURE:
•
Set drop feed button "Si" position with the needle position selector
" 1" position.
• Place button under button foot such that the needle is aligned
directly with the left hole in your button. Check alignment by
turning hand wheel and watching needle.
• Bring the needle slightly above the button and turn stitch width
knob until needle aligns with the right hole in the button.
• Run machine slowly and make 7-8 stitches.
• With needle in left hole return zigzag width knob to the "0"
position and make 3—4 stitches to tie off your button.
•
Apply the above method to sewing on buttons with four holes, hooKs,
snaps, etc.
28