Threading the machine – SINGER 5147 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

threading the machine

• Raise the presser foot to release tension

discs and make sure needle is in highest

position.

• Place spool of thread on horizontal spool pin,

as Instructed on page 13.

• Snap thread into thread guide post 1, as

shown.

• Snap thread into thread guide 2.

• Pass thread through point 3.

14

• Thread the needle-thread tension 4. Slide

thread over metal plate into tension discs.

Lead thread under needle-thread tension and

tension wire by firmly pulling thread up and
over tp the right.

• Pull thread to left behind point 5, guiding

thread up toward take-up lever.

• Thread take-up lever 6, as illustrated. Then

pass thread back down through point 5.

• Continue to guide thread through points 7

and 8, as shown.

• Thread needle from front to back and draw

about 10cm (4 inches) of thread through eye
of needle.

Advertising
This manual is related to the following products: