Inserting a zipper, Inserción de cremalleras – SINGER 2543 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Inserting a zipper
We recommend using the Zipper Foot to form an
even iine of stitching cióse to the zipper.
Recommended settings
Stitch Selection: Straight Stitch
Needle Position:
stitch Width;
Stitch Length: 2-5
Foot: Zipper (E)
Needle Plate: General Purpose (A)
When the zipper teeth are to the left of the
needle (A):
• Slide the adjusting block, (1) which slides on the
pin, across to the right.
• Snap-on the foot to the left side of the pin. (See
changing snap-on presser feet).
• Check the position of the foot by lowering the
needle into the notch on the side of the foot, to
ensure that it clears the foot.
When the zipper teeth are to the right of the needle
(B):
• Slide the adjusting block, (1) across to the left.
• Snap-on the foot to the right side of the pin. (See
changing snap-on presser feet).
• Check the position of the foot by lowering the
needle into the notch on the side of the foot, to
ensure that it clears the foot.
Inserción de cremalleras
La mayoría de los envases de cremalleras cuentan
con instrucciones completas de fácil seguimiento
sobre cómo insertar los diversos tipos de
cremalleras.
Le
recomendamos
utilice
el
prénsatelas para cremalleras, con el cual formará
una línea de puntadas uniformes y próximas a la
cremallera.
Posiciones recomendadas
Selección Punto: punto recto
Posición aguja:
J
Anchura punto: |j]l 11 ^
Longitud punto: 2-5
Prénsatelas: Cremalleras (E)
Plancha aguja: Uso general (A)
Cuando los dientes de la cremallera están a la
izquierda de la aguja (A):
• Deslice el bloque de ajuste (1), el cual se desliza
sobre el pasador, a tope hacia la derecha.
• Engarce el tronco del prénsatelas sobre el lado
izquierdo del pasador. (Ver cambio prénsatelas
de colocación instantánea).
• Compruebe la posición del prénsatelas, bajando
la aguja dentro de la muesca del lado del
prénsatelas, asegurándose de que lo pasa.
Cuando los dientes de la cremallera están a la
derecha de la aguja (B):
• Deslice el bloque de ajuste (1), el cual se desliza
sobre el pasador, a tope hacia la izquierda.
• Engarce el tronco del prénsatelas sobre el lado
derecho del pasador. (Ver cambio prénsatelas
de colocación instantánea).
• Compruebe la posición del prénsatelas, bajando
la aguja dentro de la muesca del lado del
prénsatelas, asegurándose de que lo pasa.
34