Dish Network Solo 811 - Manual (Page 20)

Page 15
The Remote Control
Telephone Jack
Connect a telephone cable with a standard RJ-11 telephone
connector to the receiver here, and then connect the cable to an
active telephone line.
Note : The receiver must be connected at all times to an active
telephone line.
The Remote Control
The remote control gives you easy access to all of the features of your satellite
receiver. You can set up the remote to control the satellite receiver, TV, VCR
and any other one piece of A/V equipment such as a DVD player and home
theater equipment.
If you are installing or re-installing your receiver, you will need to follow the
setup procedures in this chapter.
Complete instructions on how to use the remote, as well as the rest of the
system, are in Chapter 3.
Note : The remote control shown here is for example only. Your remote control
may be different.
Tip: If you have
the receiver
connected to a
DSL (Digital
Subscriber Line)
phone line and it
cannot dial out,
you may have to
install a DSL filter
between the
receiver and the
telephone jack
on the wall.