Dish Network Solo 811 - Manual (Page 77)

Page 72
Chapter 3
Using the System
Set the Remote Back to Control the TV Volume
1. Press and hold the TV mode button until all the other mode
buttons light, then release.
2. Press the POUND (#) button.
3. Press the plus (+) side of the VOLUME button.
4. Press the 0 number button.
5. Press the POUND (#) button.
The TV mode button flashes three times.
6. Press the SAT mode button.
7. Press the plus (+) and minus (-) sides of the VOLUME button.
The TV’s volume changes and the TV mode button lights instead of the
AUX mode button.
Teaching Another Remote
Your DISH Network receiver can pass certain functions through from the
original receiver remote to another remote.
Note: Although most learning remotes are compatible with the Teach
Remote option featured in your DISH Network receiver, there may be a
few that are not. Consult your universal learning remote user’s guide for
details.
The Remote Teaching Sequence
Follow these steps to teach (program) a universal learning remote from the
remote supplied with your satellite receiver.
Note: The universal learning remote is not supplied with your receiver. You
can purchase it separately at an electronics supply store.
1. Press the MENU button.
2. Select the System Setup option.
3. Select the Diagnostics option. The receiver displays the
blank System Diagnostic Tests screen.
4. Select the Teach Remote option. The receiver displays a
pop up screen warning that you must press any button on the front panel
in order to quit the teaching mode.