Dish Network Solo 811 - Manual (Page 80)

Page 75
Troubleshooting Tools
Page 75
Note : If you have the receiver connected to a DSL (Digital Subscriber Line)
phone line, it may cause this test to fail. If so, you will need to install a DSL
filter between the receiver and the phone jack on the wall. You can get a
DSL filter from your Internet Service Provider or a local electronics parts
store.
1. Press the MENU button.
2. Select the System Setup option.
3. Select the Diagnostics option.
Point Dish and Check Switch
The Point Dish and Check Switch screens are helpful to the Customer
Service Representatives. You may be asked to display these screens when
you call DISH Network. Even though there are items that can be changed,
only change them when specifically directed by a Customer Service
Representative.
1. Press MENU.
2. Select System Setup .
3. Select Installation .
4. Select Point Dish . This screen shows you information to help
maximize your satellite signal. The bar at the bottom of the screen tells
you the signal strength. Green is a good signal, while red indicates the
signal is not acceptable or is from the wrong satellite.
5. Select Check Switch to display the Installation Summary screen. The
Installation Summary screen tells you if you are receiver signals from
the satellites and which multi-dish switches you have installed, if any.
6. Select Test only if directed by the Customer Service Representative.
7. Select Done .