Dish Network Solo 811 - Manual (Page 21)

Page 16
Chapter 2
Receiver Description and Installation
Remote Control Batteries
The remote control comes with AAA batteries, which need to be
installed when you first receive your system. When you replace
old batteries, you should replace all of the batteries. Use batteries
of the same kind, for example, alkaline or carbon zinc. Don’t mix
batteries of different kinds. Alkaline batteries last longer than
carbon zinc.
1. Press down on the top of the battery cover and slide the cover
off.
2. Take out all of the old batteries.
3. Put the new batteries in. Make sure you match the plus (“+”)
ends with the plus markings on the battery case.
4. Slide the cover back into place.
On Screen Low Remote Battery Warning
When you see a low battery warning message below the Program Banner, the
batteries in your remote control are weak and need to be replaced.