Dish Network Solo 811 - Manual (Page 72)

Page 67
Control Other Devices with the Remote
Page 67
Check the Device Codes
You can find out what device code you’ve set for each remote mode. In the
following instructions, the column on the left contains the instructions and
the column on the right provides additional information.
Instructions Additional Information
7. Turn the device back on and
try some other appropriate
buttons to make sure they
work.
Press the POWER button to turn the
device back on. Try some other
buttons to make sure they work.
Sometimes, the POWER button
works when other buttons don’t.
8. Repeat this procedure until
you’ve tried all the codes.
You may need to repeat the scan to
find the best code for your device.
Instructions Additional Information
1. Press and hold the appropriate
mode button until all the other
mode buttons light up, and
then let go of the button. The
mode button flashes.
For example, hold TV for a TV until
all of the other mode buttons light.
When you let go, TV will flash.
2. Press the POUND (#) button
twice.
Watch the mode light to
determine your code. The
mode button flashes the
number for each digit of the
device code, with a pause
between the groups of
flashes. A quick flash is for
zero.
For example, if the code is 570, the
mode button flashes five times,
pauses, flashes seven times, pauses,
and flashes once quickly.
For AUX mode: The first
group of flashes tells you
what the AUX mode controls.
A quick flash (zero) before
the three-digit code is for a
TV; one regular flash is for a
VCR; and two flashes is for a
tuner, or amplifier. For example, if the TV code is 570,
the AUX mode button flashes once
quickly (indicating 0 for TV), pauses,
flashes five times, pauses, flashes
seven times, pauses, and flashes once
quickly.
For Limited Mode: If you
have programmed a TV or
VCR in Limited Mode, the
mode button flashes once at
the end of the flash sequence. For example, if the TV code is 570,
the TV flashes five times, pauses,
flashes seven times, pauses, flashes
once quickly, and then flashes once
(indicting Limited Mode).