Dish Network Solo 811 - Manual (Page 71)

Page 66
Chapter 3
Using the System
Scan for Device Codes
If the code for your device is not listed in the device codes on page 86, use
this procedure to scan the remote control’s memory for the device code. In
the following instructions, the column on the left contains the instructions
and the column on the right provides additional information.
11 If you can’t find a code that
works try, Setting Up Using
Device Codes Scan that fol-
lows.
Instructions Additional Information
1. Turn the device on. Use the device’s front panel buttons
or its remote control.
2. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let go,
the TV mode light will flash.
3. For AUX mode only. Press 0
for a second TV, or 1 for a
VCR or DVD player, or 2 for
a tuner, or amplifier. Press the
STAR (*) button.
This step is for programming which
kind of device that should be
programmed in AUX mode. If you’re
not programming in AUX mode, skip
to step 4.
4. Press the POWER button. This puts your remote in the scan
mode.
5. Press the either the UP or
DOWN ARROW button
repeatedly until the device
turns off.
As you press the UP or DOWN
ARROW button, the remote is trying
each code in the memory to see if it
can turn off your device. When the
device turns off, you have found a
code that might work.
Note The mode button for the device
will flash rapidly eight times when
you’ve scanned all the codes for that
device.
6. Press the POUND (#) button. This stores the code you found.
Instructions Additional Information