ADLINK PCI-7442 - Manual (Page 71)

Register Format 59
Power-up DO Setup/Read Back Register
After the system powers up, the PCI-7444 can enter the initial pro-
cedure which sends out the default initial value to 128-CH digital
outputs. You can configure the default power-up DO values and
store them in the flash memory to prevent the DO from entering an
unknown status when the system turns on.
You may set the 128-CH power-up default DO values by access-
ing the Power-up DO Setup Registers in turn. After accessing the
latest Power-up DO Setup Register (Base+0x24h), the card
needs at least 500 ms to finish the writing to the flash memory pro-
cedure. You may check if the procedure is finished or not by the
nAction_Ready flag.
Address R/W Value Mapping (MSB----LSB)
BASE+0x16h W IDO[15...0]
BASE+0x18h W IDO[31...16]
BASE+0x1Ah W IDO[47...32]
BASE+0x1Ch W IDO[63...48]
BASE+0x1Eh W IDO[79...64]
BASE+0x20h W IDO[95...80]
BASE+0x22h W IDO[111...96]
BASE+0x24h W IDO[127...112]
Bit value: 0: Output PowerMOSFET is OFF. (Initial value)
1: Output PowerMOSFET is ON.