GoDEX EZ6000Plus series - Manual (Page 21)

17
EZ-2000+/6000+ User ’s Manua
3. Operator panel
3-1. Operator panel – introduction
Function buttons
FEED
PAUSE
CANCEL
LED indicators
POWER
The POWER (Ready) LED
lights up when the printer
has started up and is
ready to print.
RIBBON Ribbon status indicator
MEDIA Media status indicator
3-2. Function buttons – introduction
FEED button
When you press the FEED button, the printer moves the label to the defined stop
position. If you are using continuous labels, pressing the FEED button will move label
stock until you release the button again. If you are using individual labels, pressing
the FEED button will move only one label. If the label does not stop at the correct
position, you need to run the auto-detection function on the label stock (see
Section 3-6).
PAUSE button
Pressing the PAUSE button while the printer is in standby mode will set the printer to
pause mode. The message "Pause" is shown on the LCD display. In this mode, the
printer can receive commands, but it can only process them when it is reset to
standby mode. Pressing the PAUSE button again will reset the printer to standby
mode.
Pressing the PAUSE button during printing will interrupt printing. When the PAUSE
button is pressed again, the printer resumes printing. Example: While a 10-label print
job is running, you press the PAUSE button to pause the printer. Two of the labels
have been printed. To resume printing and print the remaining eight labels, you
press the PAUSE button again.
CANCEL button
Pressing the CANCEL button during printing cancels a print job. The message "Print
job cancelled" is shown on the LCD display. The current print job is cancelled.
Example: While a 10-label print job is running, you press the CANCEL button. Two of
the labels have been printed. The print job is cancelled and the remaining eight
labels are not printed.