GoDEX EZ6000Plus series - Manual (Page 29)

25
EZ-2000+/6000+ User ’s Manua
3-5. Dump mode
If the label settings do not match the printer output, you should switch the printer to
dump mode to check whether an error has occurred during the transfer between
printer and host computer. In dump mode, the unprocessed raw data are sent to the
printer and printed. This shows you quickly whether any data are sent to the printer at all.
Here is how you switch to dump mode:
1.
Switch off the printer.
2. Switch on the printer, keeping the FEED button pressed.
3. When the message "Dump Mode" appears on the display, release the FEED button.
The
printer will automatically print "Dump Mode Begin". That means the printer is now in
dump
mode.
4. Send commands to the printer and check whether they match the printer output.
To exit dump mode, press the FEED button. The printer will automatically print "Out Of
Dump Mode" and switch to standby mode. Alternatively, you can switch off the printer
to exit dump mode.
3-6. Label size calibration
The printer can automatically detect and store label height.
That means the host computer does not need to transmit the label height to the printer.
1.
Check that the label sensor is positioned correctly.
2. Switch off the printer.
3. Switch on the printer, keeping the PAUSE button pressed. When you hear 3 beeps
and the
message "Auto Sensing Mode" appears on the display, release the PAUSE button.
The
printer will now automatically measure the label size and store this information.
4. The label height in mm is shown on the display.
After displaying the label height, the printer switches back to standby mode.