GoDEX EZ6000Plus series - Manual (Page 43)

39
EZ-2000+/6000+ User ’s Manua
4-4. Internal rewinder for EZ6000 Plus
1 Motor
1
2
3
4
5
6
7
8
2 Rewinder
3 Rewinder connector bracket
4 Retention clip
5 Rewinder guide
6 Cable tie
7 Belt
8 Screws (set of 10)
【 Note 】
For EZ-6200 Plus, the printing speed will
be limited to 4 IPS when the rewinder
or label dispenser is enabled.
1. Place the printer on a flat surface
and open the printer cover.
2. Remove the screws securing the
left-hand part of the housing and
the printer cover and remove
these two parts of the housing.
【 Note 】
Remember to switch off the printer
before starting the installation.
3. Remove the connectors from the
power supply unit in the two
places marked.
4. Remove the two screws that
secure the power supply unit on
the bottom of the printer housing.
5.
Remove the power supply unit.
6. Remove the cable connecting
the motherboard and the
connector bracket.