Laerdal SimView - Manual (Page 21)

21
5.2.10 Unified Patient Monitor
When using the unified Patient Monitor you don’t need to know the IP address of the monitor, as it will be
shown in the search list. The requirement is that the Patient Monitor is setup in the LLEAP application on
the PC acting as Patient Monitor.
1. From the Home screen click the VIEW & SETUP (1)
2. Click the Add equipment (2) button.
3. Click the in the Devices (3).
4. Select the Unified Patient Monitor by clicking in the drop down list (4).
5. Select the required Patient Monitor from the list (5 and 6), if not shown, click the Search again
button.
6. Click the Add equipment (7).
Figure 40
Figure 41
Figure 42
Figure 43