Laerdal SimView - Manual (Page 42)

42
Figure 89
The automatic clean-up for saved simulation is enabled on the server settings by entering the number of days
that simulation have to be older than in order to be deleted (1), and then click in the check to enable the
feature checkbox and save changes (2), you will get at warning to alert you about the automatic deletion of
files. (See Figure 89)
Note! Sessions marked as protected will not be deleted.
System notification 7.4
Figure 90
If you get this message you will have to click it and under server setting you will see what caused the
warning.
Note! Only the admin user is able to see the information in the Server settings
Figure 91
Solve the issue indicated in the System notification area. This can be system driver upgrade, an Upgrade
notification or as shown here a hard disk clean-up.
If the server is connected to the Internet you will get an Upgrade notification if there is a newer version of
the SimView software, the software is not automatically updated, but you can download from
www.laerdal.com/download and install it on the server.