Laerdal SimView - Manual (Page 39)

39
Functions during debriefing 6.12
The following chapters will show the different functions during debriefing.
6.12.1 The timeline
The timeline in the bottom of the Viewer Window can be used to search forward and backward in the
session. The timeline size can be controlled by clicking the double arrow that shows up in the right top
corner of the frame when the cursor is inside the timeline. Clicking inside the timeline will move the video
forward or backward, depending on clicking in front or behind the actual play time.
Holding the cursor over the vital signs will activate a pop-up with the values of the vital signs at that time.
Figure 85 The different timeline views
6.12.2 Basic and Detailed Views
The simulation log can be showed with two different levels of detail in the Event Log.
As seen on Figure 86 there are a lot more information in the detailed view, so if you want to just get an
overview of the session; use the basic view.
Figure 86 The difference between Basic View and Detailed View
You can change between the views by using the pull-down menu in the Event Log view and then select Basic
View, Detailed View or Original View
Note! You cannot edit the event log in the Original View. The Original view is the raw data from the
simulation session