Doremi AccessLink - Manual (Page 19)

FAL.OM.002372.DRM Page 19 of 62 Version 1.6
Doremi Labs
3 Installation
Follow the steps below to set up the AccessLink and Fidelio System.
For the connection diagram, please refer to Section 10.
3.1 Charging Station/Tablet

You will need to first connect the touchscreen tablet to the Fidelio
Charging/Configuration Base using the tablet bracket.
3.1.1 Connection of the Tablet Bracket to the Configuration/Charging
Station Base

Place the Fidelio Configuration/Charging Station Base upside down near the edge of a
table so that the Tablet bracket can hang down and sit flush with the bottom of the base.

Line up the four (4) holes of the tablet mounting bracket to the four (4) holes of the
Charging/Configuration Base.

Using a Phillips screwdriver, carefully secure the Tablet Mounting Bracket to the
Charging/Configuration Base using the four (4) M3x6 Black Flat Head Machine Screws
provided.
3.1.2 Installation of Tablet into the Stand Bracket

Turn the Fidelio Configuration/Charging Station Base over so that it is sitting upright.

Loosen the Tablet Clip screws.

Slide the Touchscreen Tablet from the right-hand side of the Bracket grooves until the
Tablet is centered on its mounting bracket.

Tighten the Tablet Clip Screws to secure the Touchscreen Tablet in the bracket (Figure
14).