Doremi AccessLink - Manual (Page 34)

FAL.OM.002372.DRM Page 34 of 62 Version 1.6
Doremi Labs
4 Assigning the Fidelio Receiver to an Auditorium
 First you will need to plug the large end (Type B) of the USB cable into the USB port
located on the right-hand side of the Fidelio charging station base and the smaller end
(Mini A) into the micro USB port located on the right-hand side of the Fidelio touchscreen
tablet (Figure 20).

Power up the Fidelio touchscreen tablet by depressing the power switch located on the
top right-hand side of the tablet (Figure 10).
Note: You will need to keep pressure on the switch until the Android splash screen comes up.
 After the Fidelio touchscreen tablet has finished booting up, you will need to unlock the
screen by using your finger on the unlock padlock icon and sliding up on the touch
screen (Figure 22).
 Once unlocked, you will be presented with the Fidelio application icon screen.
 Using your finger, touch the Fidelio application icon to launch the application (Figure 24).
 The tablet will display a message saying, “Looking for Fidelio Devices” (Figure 25).
 Place a Fidelio Receiver into the port labeled, “Configuration Port,” on the Fidelio
charging station base.

The tablet will then display the Receiver display screen. This screen will provide you with
the Auditorium and Channel assignments for the Receiver (Figure 35).
Figure 35: Receiver Auditorium and Channel Assignments Screen
 To change their assignments, simply touch the corresponding Change button
(Figure 35).