Doremi AccessLink - Manual (Page 41)

FAL.OM.002372.DRM Page 41 of 62 Version 1.6
Doremi Labs
5.2.2 Configuring the Network via CLI
Note: This method is valid for all AccessLink software versions.
5.2.2.1 IP Configuration

To configure the IP of the AccessLink, type the following command (xxx.xxx.xxx.xxx =
the desired IP address):
echo -n xxx.xxx.xxx.xxx > /doremi/etc/ip_addr <Enter>

To configure the netmask type the following command:
echo -n xxx.xxx.xxx.xxx > /doremi/etc/netmask <Enter>

To configure the gateway type the following command:
echo -n xxx.xxx.xxx.xxx > /doremi/etc/gateway <Enter>
5.2.2.2 NTP Servers (Optional)

To add a new line to your NTP setup, type the following command while replacing the
bold item with your desired NTP settings:
echo NTPSERVERS="server_1" >> /doremi/etc/ntpservers <Enter>
5.2.2.3 DNS (Required for NTP)

To add a new line to your DNS, type the following command:
echo “nameserver 172.17.16.1” >> /doremi/etc/resolv.conf <Enter>
5.3 Configuring the Transmitter's Auditorium Number
Note: This is the only method valid for all AccessLink software versions. For more information
on logging into the Command Line Interface (CLI), see Section 5.5.

To change the auditorium of the CaptiView Transmitter Dongle, replace the bold item
with a number that is in the range of 1-32. Make sure that no two transmitters are
configured with the same auditorium number:
echo -n aud_number > /doremi/etc/s430-10/audi.conf <Enter>

Reboot for the changes to take effect.
5.4 Adding the IP of the Digital Cinema Server to the AccessLink
Note: This is the only method valid for all AccessLink software versions. For more information
on logging into the Command Line Interface (CLI), see Section 5.5.

To add the IP address, type the following command:
echo -n xxx.xxx.xxx.xxx > /doremi/etc/s430-10/ip.conf <Enter>

Power cycle the Accesslink for the changes to take effect.