Doremi AccessLink - Manual (Page 42)

FAL.OM.002372.DRM Page 42 of 62 Version 1.6
Doremi Labs
5.5 Logging into AccessLink
5.5.1 Logging into AccessLink via SSH

The default IP address of the AccessLink is 192.168.9.10.

Set your computer's IP address in the range '192.168.9.xx', xx being in the range (2-254
except 10 when using default IP).

Connect the AccessLink with an Ethernet cable to the newly configured port and power
ON.

Download and install the program "PuTTY" (or any ssh client) on the computer you just
assigned the new IP address to.

Connect to the default IP 192.168.9.10 on port 22 using the ssh client.
Note: If the IP address was changed using the USB method, use the IP address that was
assigned to the AccessLink instead of the default IP.

When the unit is done booting up, log in as "root."
o Password for "root:" "veeone"
o It is recommended to change the "root" password by typing the following
command and following the on-screen instructions: "passwd"
5.5.2 Logging into AccessLink via Serial Port

The serial cable required for a proper connection is a female-to-female, pin-to-pin cable,
which should be provided in the package.
◦ Serial connection settings are:
▪ Speed 115200
▪ Data bits: 8
▪ Stop bits: 1
▪ Parity: None
▪ Flow control: None
◦ Connect and switch the device on and wait for it to boot.

When the unit is done booting up, log in as "root."
◦ Password for "root" is “veeone”
It is recommended to change the root password by doing this command and following the on-
screen instructions: "passwd"