Desa (V)DVF36 - Manual (Page 27)

www.desatech.com 56131-F 7
bURNER FLAME
ADjUSTMENT
Continued
Figure 56 - Burner Removal
4. Slide burner forward off orifice and turn to
one side to clear opening in hearth pan. Be
careful not to bend or damage pilot or ignitor
element.
5. To reinstall burner, follow reverse steps
making sure air shutter on burner tube is
completely seated over orifice mount.
6. Replace log set. Close door and latch. Reattach
screen and louvers.
CAUTION: Make certain ori-
fice is fully inside venturi tube's
air shutter and that air shutter is
adjusted accordingly, see Figure
54, page 26.
OPERATING GUIDLINES
AND MAINTENANCE
INSTRUCTIONS
When lit for the first time, the appliance may emit a
slight odor for about 16 - 24 hours. This is normal and
is due to the “curing” of the logs and the “burn-in” of
internal paints and lubricants used in the manufactur-
ing process. Keep compartments, logs, burners, and
area surrounding the logs clean by vacuuming or
brushing at least twice a year. Temporary removal
of the log set may ease the cleaning of the burner and
pilot assembly. In cleaning, take care not to alter the
pilot or burner location. Be sure appliance is cool
before each maintenance session.
Glass Door
Refractories
Grate and
Logs
Burner
Hearth Pan
Louver
Assembly
CAUTION: The appliance and
logs can get very hot - Handle
only when cool.
WARNING: Turn off gas and
wall switch before servicing
appliance. Any safety screen or
guard removed for servicing the
appliance must be replaced prior
to operating the appliance.
WARNING: Make certain
wires and gas lines are not
touching the underside of the
firebox.
WARNING: Children and
adults should be alerted to the
hazards of high surface tem-
peratures, and to stay away from
the appliance to avoid burns or
clothing ignition. Young children
should be carefully supervised
when they are in the same room
as the appliance.
WARNING: Have a qualified
agency periodically inspect the
vent system at the start of each
heating season, for any obstruc-
tion which may hinder its normal
operation. Never obstruct the
flow of combustion and venti-
lation air. Keep the front of the
appliance clear of all obstacles
and materials.
CAUTION: Label all wires
prior to disconnection when
servicing controls. Wiring errors
can cause improper and danger-
ous operation.