Operating fireplace, Operating guidelines and maintenance instructions, Millivolt – Desa (V)DVF36 User Manual

Page 28

Advertising
background image

www.desatech.com

56131-F

8

OPERATING FIREPLACE

MILLIVOLT

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,

follow these instructions exactly.

B. BeFore LiGhTiNG smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WhAT To Do iF YoU SMeLL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not use

any phone in your building.

• immediately call your gas supplier from

a neighbor’s phone. Follow the gas

supplier’s instructions.

• if you cannot reach your gas supplier, call the

fire department.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. if the

knob will not push in or turn by hand, don’t

try to repair it, call a qualified service tech-

nician or gas supplier. Force or attempted

repair may result in a fire or explosion.

CLEANING AND REPLACING
GLASS DOOR

Note:

Before proceeding, make sure unit is com-

pletely cool.

1. Remove top and bottom louvers and screen

assembly. Undo 4 latches and open glass door.

The procedure is the same for the end lover

panel but the entire frame must be removed

as one assembly.

2. To clean glass door, DO NOT remove glass

from frame. Use any glass cleaner to clean

glass. Do not use abrasive cleaners as this may

damage glass.

3. If replacement is necessary, the entire assem-

bly (frame and glass) must be replaced. If glass

is broken, wear gloves and tape remaining

fragments onto the frame. Remove 5 screws

located on end of firebox while holding frame

assembly to prevent it from falling and caus-

ing injury (see Figure 57). Mount new frame

at hinge with 5 new screws. Close and latch

door. This will seat the gasket. If replacing end

glass panel, remove 16 screws around frame

(see Figure 58) To insure proper fit, when

installing new glass panels make sure seam

in gasket is placed in the down position.

4. Replace screen assembly and top and bottom

louvers.

OPERATING GUIDELINES

AND MAINTENANCE

INSTRUCTIONS

Continued

Figure 57 - Removing Glass Door

Figure 58 - End Panel Replacement

Glass
Assembly

Frame
Assembly

Louver Assembly

Retainer Screws

Screws

Hinge

Advertising