Installation, 1 introduction, Section 2.1 – Adept AnyFeeder User Manual
Page 19
Adept AnyFeeder User’s Guide, Rev. B
19
Installation
2
2.1
Introduction
This chapter describes the installation procedure for the Adept AnyFeeder.
In addition to installing the Adept AnyFeeder, you will need to install the following items
in the workcell:
• Robot: one of the following:
• Adept robot that interfaces with an Adept SmartController CX, running V+
version 16.x or later
OR
• Adept i-Series robot (Adept Cobra i600 or Adept Cobra i800 robot)
• Vision: an Adept SmartController CX
• Licenses: V+ Extension, Guided Vision
• An available serial port
• Camera: a user-supplied camera (with lens) and a vision system
• Camera interface cables
• User-supplied personal computer (for interfacing with and programming the
robot and vision system)
• All required safety devices (light curtains, guarding, etc.) for the workcell