Adept AnyFeeder - Manual (Page 28)

Chapter 2 - Installation
28 Adept AnyFeeder User’s Guide, Rev. B
Connecting the Power Cable
1. Locate the DC power cable with connector that was supplied with the Adept
AnyFeeder (see Figure 2-10 ).
Figure 2-10. DC Power Cable
2. Connect the wire end of the cable to the user-supplied 24 VDC / 10 A regulated
power supply.
3. Attach the connector end of the cable to the Motor Power 24 VDC In (J1)
connector on the front of the Adept AnyFeeder (see Figure 2-11 ).
Figure 2-11. 24 VDC In Connector