Adept AnyFeeder - Manual (Page 51)

Removing and Installing the Feed Surface
Adept AnyFeeder User’s Guide, Rev. B 51
a. Spray the cleaning product onto a clean shop towel.
b. Wipe the feed deck with the shop towel to remove any dirt or debris.
7. Unpackage the new feed surface. The feed surface is self-lubricating. Therefore,
no lubricants should be applied to the feed surface.
8. Slide the new feed surface into the feed deck.
9. Re-tighten the screws on the side rails.
10. Turn on the power and air supply to the Adept AnyFeeder.
CAUTION: Use only a non-abrasive, no-residue cleaner, such as
rubbing alcohol or window cleaner applied to a clean shop towel. Do
not spray cleaner directly onto the feed deck.