Adept AnyFeeder - Manual (Page 53)

Adept AnyFeeder User’s Guide, Rev. B 53
Optional Equipment
6
6.1 Introduction
This chapter describes optional equipment that is available for the Adept AnyFeeder.
6.2 Backlight
This section describes the procedure for installing the backlight option on the Adept
AnyFeeder. A red (P/N 05284-201) and an infrared (P/N 05284-202) backlight are
available.
1. Slide out the feed surface from the back of the Adept AnyFeeder.
2. Use a 2.5 mm Allen wrench and 7 mm wrench or socket to remove the two screws
from the feed platform front cover.
Figure 6-1. Removing the Feed Platform Front Cover
3. Insert the backlight power plug into the 4-pin connector in the Adept
AnyFeeder’s base housing. Screw in the plug to secure it in place. Make sure the
plug is oriented toward the back of the Adept AnyFeeder, as shown in the
following illustration.