6 verifying the installation, Figure 2-13. i/o power and motor power leds, Figure 2-14. serial mode indicator led – Adept AnyFeeder User Manual
Page 30
Advertising
Chapter 2 - Installation
30
Adept AnyFeeder User’s Guide, Rev. B
2.6
Verifying the Installation
This section describes the procedure for verifying the Adept AnyFeeder after installation.
After wiring the system, turn on the 24 VDC power supply and verify that the two (2)
Status LEDs are on (see
).
Figure 2-13. I/O Power and Motor Power LEDs
Additionally, the LED shown in
will blink to indicate Serial mode.
Figure 2-14. Serial Mode Indicator LED
Advertising