Adept AnyFeeder - Manual (Page 20)

Chapter 2 - Installation
20 Adept AnyFeeder User’s Guide, Rev. B
2.2 Unpacking
This section describes the procedure for unpacking the Adept AnyFeeder.
Figure 2-1. AnyFeeder Parts
The Adept AnyFeeder is shipped in a carton that is banded onto a wooden pallet. The
shipping carton with pallet is approximately 1219 mm (48 in) x 762 mm (30 in) x 431.8 mm
(17 in) (L x W x H). The shipping carton with pallet weighs approximately 80 kg.
To unpack the Adept AnyFeeder:
1. Use a forklift or hand truck to move the shipping carton with pallet to the
installation area.
2. Cut the banding with a utility knife or scissors.
3. Raise the shipping carton cover straight up until it clears the contents, and then
remove it.
4. Detach the Adept AnyFeeder from the shipping pallet by using a 4 mm Allen
wrench and 10 mm wrench or socket to remove the four (4) screws from the
mounting rails of the Adept AnyFeeder, as shown in
Figure 2-2 .
Feed platform
Interface panel
Feed platform
front panel
Bulk container
Mounting rail
Pneumatic connector