Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 74)

Functional Description
ATCA-8310 Installation and Use (6806800M72E) 74
4.2.1.2.2 Boot Bank Selection and Reprogramming
By default, the payload processor boots from Boot Flash device #1. An IPMI OEM command can
be used to send a message to the IPMC to change the boot device. The IPMC provides an IPMI
sensor to control the signal BOOT_SELECT. Write protection is implemented through the
FPGA.
The update mechanism is described in the software specification. The principal is to store the
information which device was used to boot from and keep that device protected. The
redundant device can then be upgraded as needed.
In case of an IPMC firmware upgrade, the BOOT_SELECT signal stays unchanged. Besides
others, this signal is latched by a latch buffer to ensure that its state doesn't change when the
IPMC resets hard.
Figure 4-3 Boot Flash Switching

Glue 
FPGA 
SPI 
Flash 
#1 
SPI ͲInterface
ACS 
8520 
P4080  CS0/1# 
CS1# 
SPI 
Flash 
#2 
Boot1_CS0/1#
Boot2_CS1/0#
IPMC_BOOTSEL#
Manual_BOOTSEL#
IPMC  BOOT_SELECT# 
WP
WP
P4080 ͲRESET