Avery Dennison Monarch 9855 Operator Handbook - Manual (Page 37)

Setting Supply Options 4-3
S e t t i n g t h e S u p p l y T yp e
You can print on aperture, black mark, die cut, or continuous supplies. You
have to tell the printer which supplies you are using.
Note: If you are using edge aperture supplies, use the die cut setting. If
you are using center aperture supplies, use the aperture setting.
To change the setting, from the Main Menu, select Setup, then Supply. If
password protection in enabled, press Feed/Cut three times, then press
Enter/Pause before you see the Setup Menu options. Then, follow these
steps.
1. Press  or  until you see
SUPPLY
Supply T ype 
2. Press Enter/Pause to set the supply type option. The current setting is
displayed, for example:
SUPPLY T YPE
 Black Mark 
3. Press  or  to see the other options. After you display the option you
want, press Enter/Pause. Press Escape/Clear until you see the Main
Menu.