Beisler 1220-4 - Manual (Page 54)

Operating manual Automatic single head serging unit 1220/4
Page 6-30 © Beisler GmbH, Hösbach
1. Remove the stitch plate and loosen screws (1) (2) (3) a
little.
2. Turn the hand wheel until the transporters stand in their
highest positions.
3. Lay on the stitch plate.
4. Adjust the height of the transporters, that the cogs of the
main transporter stand 0.8mm, those of the differential
transporter (5) 0.9 to 1 mm and those of the additional
transporter (6) 0.6 to 0.7 mm above the top edge of the
stitch plate.
5. Tighten screws (1) (2) (3) in this position.
6. Mount the stitch plate.
6.5.8 Stroke of the presser foot
Pict. 30 Stroke of the presser foot (1)