Compuprint 4247-L03 Programmer Manua - Manual (Page 49)

The total number of characters that will be printed from the table of all printable characters is equal to n
1
+
(n
2
x 256). For example, to print 300 characters from the table of all printable characters: n
1
= 44, n
2
= 1.
The control codes are not recognized as long as this sequence is active. The space character is printed as
an unassigned character.
ESC ^
Prints a single character from the all characters table. (IBM)
ASCII Code ESC ^ n
Hexadecimal Value X'1B' X'5E' n
Decimal Value 27 94 n
Range 0 ≤ n ≤ 255
This command prints the next character from the all characters table. This sequence prints only one
character from the all character table.
ESC 6
Selects the Character Set 2 (IBM).
ASCII Code ESC 6
Hexadecimal Value X'1B' X'36'
Decimal Value 27 54
This command selects the character set 2.
ESC 6
Enable Printable Code Area Expansion (EPSON).
ASCII Code ESC 6
Hexadecimal Value X'1B' X'36'
Decimal Value 27 54
ESC 7
Selects the Character Set 1 (IBM).
ASCII Code ESC 7
Hexadecimal Value X'1B' X'37'
Decimal Value 27 55
This command selects the character set 1.
ESC 7
Cancel Printable Code Area Expansion (EPSON)
ASCII Code ESC 7
Hexadecimal Value X'1B' X'37'
Decimal Value 27 55
Chapter 2. EPSON/IBM Mode 33