Compuprint 4247-L03 Programmer Manua User Manual
Page 62
init
Description
0
Initializes the printer to user-default settings. The download font remains
unchanged. If parameters are specified, they overwrite the default settings.
If the emulation mode is changed, the download font is initialized. This
command only copies data from the selected macro, adds parameter
changes, if any, and stores it in working RAM. The data stored in the
macro's nonvolatile RAM is not affected.
1
Initializes the printer to user-default settings. The download font is
initialized. If parameters are specified, they overwrite the default settings.
This command only copies data from the selected macro, adds parameter
changes, if any, and stores it in working RAM. The data stored in the
macro's nonvolatile RAM is not affected.
4
Initializes the printer to factory settings. The download font remains
unchanged. If parameters are specified, they overwrite the default settings.
If the emulation mode is changed, the download font is initialized. This
command only copies the default settings from ROM, adds parameter
changes, if any, and stores it in working RAM. The data stored in the
macro's nonvolatile RAM is not affected.
5
Initializes the printer to factory settings. The download font is initialized. If
parameters are specified, they overwrite the default settings. This
command only copies the default settings from ROM, adds parameter
changes, if any, and stores it in working RAM. The data stored in the
macro's nonvolatile RAM is not affected.
254
Initializes the printer to user-default settings. The download font is
initialized. If parameters are specified, they overwrite the default settings.
This command changes the data stored in the selected macro. It copies
data from the selected macro, adds parameter changes, if any, and stores
it in working RAM and in the selected macro. It also changes the default
macro to the value of parm 3.
255
Initializes the printer to default settings. The download font is initialized. If
parameters are specified, they overwrite the default settings. This
command changes the data stored in the macro's nonvolatile RAM. It
copies default settings from ROM, adds parameter changes, if any, and
stores it in working RAM and all macros. It also sets the default macro to
disable.
id
The id parameter specifies the printer for which the following parameter bytes are
intended. If the ID does not address your printer, the mode bytes that follow are ignored.
The ID values are Hex = X'B6', Dec = 182.
parm
1
Specifies the following functions:
Bit
Not set
Set
7
Discard byte
Process this byte
Ignore this byte
6
Reserved
5
Alarm
Alarm enabled
Alarm disabled
4
Automatic CR
No CR on vertical movement
CR on vertical movement
3
Automatic LF
No LF after CR
LF after CR
2
Page length
11 inches
12 inches
1
Slashed zero
Zero without slash
Zero with slash
0
Character set
CS1
CS2
46
Programmer Manual