Compuprint 4247-L03 Programmer Manua - Manual (Page 97)

The proprietary defined parameter values are:
p MNEMONIC MODE FUNCTION
1 PRM0 Proportional Print Mode
3 CSI Single Character CSI Mode
4 BLD Bold Mode
5 CS2 Character Set 2 Mode
The ANSI defined parameter values are:
p MNEMONIC MODE FUNCTION
0 Ignored
20 LNM Auto CR on LF
ESC p
1
; p
n
l
Resets mode (RM).
ASCII Code ESC p
1
; p
n
l
Hexadecimal Value X'1B' X'5B' p
1
X'3B' p
n
X'6C'
Decimal Value 27 91 p
1
59 p
n
108
This sequence resets the print mode(s) indicated by the p1/pn parameter(s).
ESC [ p
1
; p
2
SP~
Selects emulation (EMU).
ASCII Code ESC [ p
1
; p
2
SP~
Hexadecimal Value X'1B' X'5B' p
1
X'3B' p
2
X'20' X'7E'
Decimal Value 27 91 p
1
59 p
2
32 126
This sequence selects the emulation according to p values. The p
1
parameter is an emulation identifier
value while p
2
is a reset control value.
The proprietary defined parameter values are:
p
1
p
2
FUNCTION
0 ANSI
1 - 20 Reserved
21 IBM Proprinter XL 24/24E
22 EPSON LQ 1050
0 Hold values (default). The current settings remain valid after changing the printer emulation.
1 Full reset. The status of such parameters reverts to defaults dependent on the selected
emulation.
To select ANSI mode from the Proprinter XL 24 mode and maintain the parameters, the sequence would
be: <ESC>[0; 0<SP>~ Leading zeros and defaulting parameters are not guaranteed to be parsed and
therefore should not be used by the application. Parameter p
1
& p
2
will be expressed as ASCII, not binary,
values. In the example above, “0” is “30H”, not “00H”.
Chapter 4. ANSI Emulation Commands 81