Comtech EF Data CRS-500 - Manual (Page 148)

CRS-500 1:N Redundancy System Revision 2
Ethernet-Based Remote Product Management MN-CRS500
8–10
8.5.3.2 Config (Configuration) pages
Select the Redundancy, Modem, or Remote Management tab to continue.
8.5.3.2.1 Config | Redundancy
Use this page to configure the switch communications, operations, and alarms/faults handling
for 1:N redundancy.
Figure 8-2. Config | Redundancy Page
Redundancy Configuration
Using the drop-down lists:
• Switching Mode – Select the switching mode as either Manual or Automatic.
• Capacity – The default redundancy configuration is 1:N.
2:N is reserved for future use and is not selectable or operable at this time.
Once the desired configuration settings have been made in this section, click [Apply] to save
these changes.