Comtech EF Data RCS20 - Manual (Page 72)

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–38
4.3.2.9 MODEM PORT CONFIGURATION
This screen displays the Remote Port Baud Rate and allows the user to cycle to Subscreens to change
the configurations. The baud rate may be any of the following:
9600 19200 38400 57600
1. Press <BAUD> to cycle to the REMOTE PORT BAUD RATE CONFIGURATION Subscreen to
change the baud rate.
2. Press <CLR> to abort programming (no switch parameters changed).
3. Press <ENT> to load the information on the screen into the switch parameter table. Switching will
occur immediately after pressing <ENT>.
Key Label Function
S1 BAUD Press to cycle to the REMOTE PORT BAUD RATE CONFIGURATION Subscreen.
S2 --- N/A
S3 --- N/A
S4 NEXT Press to cycle to the next screen.
Numeric Keypad --- Press <CLR> to abort programming (no switch parameters changed).
MODEM PORT CONFIGURATION
RCU20 MODEM PORT BAUD RATE : 9600
BAUD NEXT