Comtech EF Data RCS20 - Manual (Page 91)

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–57
2. Press <TOG MODE> to toggle between YES and NO. ‘Y’ indicates an alarm is masked, ‘N’
indicates an alarm is not masked.
3. Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
4. Press <ENT> to load the information on the screen into the switch parameter table.
Key Label Function
S1  Press to move the blinking cursor up through the list of faults.
S2  Press to move the blinking cursor down through the list of faults.
S3 Y/N Used to toggle between YES (masked) and NO (not masked).
S4 NEXT Press to cycle to the next screen.
Numeric Keypad ---
Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
Press <ENT> to load the information on the screen into the switch parameter table.
4.3.3.6 SWITCH MAJOR ALARMS 2
These screens display additional major alarms.
CAUTION
Masking alarms may cause undesirable modem performance
Key Label Function
S1  Press to move the blinking cursor up through the list of faults.
S2  Press to move the blinking cursor down through the list of faults.
S3 TOG MODE Used to toggle between YES (masked) and NO (not masked).
S4 NEXT Press to cycle to the next screen.
Numeric Keypad ---
Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
Press <ENT> to load the information on the screen into the switch parameter table.
SWITCH MAJOR ALARMS
MASK
BACKUP1 MOD ERROR : PASS NO
BACKUP1 DEMOD ERROR : FAIL NO
BACKUP2 MOD ERROR : PASS NO
BACKUP2 DEMOD ERROR : FAIL NO
  TOG MODE NEXT