Comtech EF Data RCS20 - Manual (Page 76)

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–42
4.3.2.14 SET TIME
This subscreen allows the user to configure the real-time clock function for the RCS20.
4.3.2.14.1 Programming steps:
1. Press  or  to move the blinking cursor the hour, minute, or second.
2. Press <UP> to increase the value of the hour, minute, or second (at the location of the blinking
cursor). Press <DOWN> to decrease the value of the hour, minute, or second (at the location of
the blinking cursor).
3. Press <CLR> to abort programming (no switch parameters changed).
4. Press <ENT> to load the information on the screen into the switch parameter table
IMPORTANT
The RCS20 real-time clock functions on 24-hour time.
Example: 13:40 hrs displayed on the unit is 1:40 pm.
Key Label Function
S1 
Press to move the blinking cursor to the left. Used to select Seconds, Minutes, and/or
Hour to be changed.
S2 
Press to move the blinking cursor to the right. Used to select Hour, Minutes, and/or
Seconds to be changed.
S3 UP Press to increment the selected field.
S4 DOWN Press to decrement the selected field.
Numeric Keypad ---
Press <CLR> to abort changes and cycle back to the TIME / DATE CONFIGURATION
Screen.
Press <ENT> to accept the selected date.
SET TIME
TIME : 09:l5:59
<--- ---> UP DOWN